Ningguo Hubang Electronic Technology Co., Ltd.
Main products:Induction lamp,Ballast,lamp,Fixture
Products
Contact Us
  • Contact Person : Ms. Wen Joyce
  • Company Name : Ningguo Hubang Electronic Technology Co., Ltd.
  • Tel : 0086-563-4303568
  • Fax : 0086-563-4309760
  • Address : Anhui,Ningguo City,West of Binkou Road, Heli Zone,Ningguo Economic And Technological Development Area
  • Country/Region : China
  • Zip : 242300

PRIVATE SOLAR CHARGE CONTROLLER OF ELECTRDELESS INDUCTION LAMP solar charge controller

PRIVATE SOLAR CHARGE CONTROLLER OF ELECTRDELESS INDUCTION LAMP solar charge controller
Product Detailed
model: HB HBSL voltage range: 6 12 24 48(V) solar charge controller

PRIVATE SOLAR CHARGE CONTROLLER OF ELECTRDELESS INDUCTION LAMP solar charge controller

model: HB HBSLvoltage range: 6 12 24 48VInstall Range Of tube and ballast: <<8MShape Dimension: 138x91x29mm
 

Technical Specification-solar charge controller:

It can be used in direct-current electroless lamp,direct-current high-pressure sodium lamp,direct-current energy-saving lamp,direct-current LED and so on.

This product has many characteristics : Strong anti-jamming \ stable performance \ accurate voltage control and so on. It uses the technology of digital circuit and the analog circuits, has completely overcome the power consumption, unstable MCU transient characteristic and the anti-jumming insufficient in similar products.

1.In the night, load opened automatically , and it uses the way of full voltage to open, lightens the load at the same time.

2. Avoiding the after-put restoration, so long as appears one time to after-put, the controller will lock, to protect the battery and the load thoroughly.

3. Charge way is the highly effective PWM, normal straight charge, floating charge, and small current and rated voltage charge. When the battery’s voltage surcharged, it selects the method of separating the charge return route to deal with it. .

4. Direct-viewing LED instruction, LED light bright indicates the charging status.

5. Fixed time can be adjusted to 10H,8H, 6H, 4H freely. The factory seting time is 10 hours.

Correct installation steps:

1. Connect the load to the controller LOAD side, pay attention to the positive and negative polarity. 2.Batteries receive the controller BAT end,pay attention to the positive and negative polarity.

3. Finally connected the solar board wiring to the controller SL end, do not make the polarity opposite,if the load delay to receive power, the lamp will delay to turn-off . Dismantle the controller it should be according to the opposite orders

4. In order to ensure the controller working normally, Short-circuiting, connecting wrong or opposite are forbided strictly. The company provides two years quality guarantee.

PRIVATE SOLAR CHARGE CONTROLLER OF ELECTRDELESS INDUCTION LAMP solar charge controller



Copyright Notice @ 2008-2012 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.